They collected dirty laundry, put it in the drum of your home assistant, installed the necessary program and started it. However, after a short period of time, instead of pumping water and adequately fulfilling the set mode, the unit stops and displays a breakdown with the abbreviation IE / E7 / 1C on its screen. In rare cases, a characteristic audible click may be heard before turning on the drain pump.
It should be noted! In no case should you forget that the fault 1E is not E1, they have completely different meanings.
You can detect such a malfunction for the first time in any mode, without the pattern of its manifestation. Subsequently, the device will not work at all immediately after startup, it stops and displays a malfunction.
If the manufacturer does not provide a display in the device, the malfunction is displayed using LED illumination: blinking LEDs indicating a temperature of 60 ° C, 40 ° C and washing in cold water.
Fault value
Fault 1 E / 1C occurs when the water level sensor is not working, i.e. a special controller does not transmit information (information) about the amount of water injected for washing or rinsing to the control module. If the machine cannot independently determine the level of water availability, then it displays a malfunction and stops responding to the established modes.
It should be noted! In modifications of machines that were developed by the manufacturer in the period up to 2007, this malfunction is displayed in the form of the abbreviation E7. Such a breakdown manifests itself as a result of the inability to determine the level of water in the tank of the device. After which the pump works and pumps out the collected water, then the machine stops and the fault code is displayed on the screen.
Mostly the abbreviation 1E / 1C / E7 indicates a serious breakdown (the pressure switch is defective), so only a specialist can eliminate it.
Breakdown E7 / IE / 1C, how to fix it without professional intervention
You can easily eliminate some malfunctions without professional training and special knowledge.
- Software crash. To eliminate it, you must perform a forced reboot. Disconnect the unit from the power supply for a period of plus or minus 15 minutes, then connect it. As a result of the shutdown, all previous commands should be reset and the machine should begin to adequately respond to the established modes and will work without problems.
- Violation of the integrity of the contact circuit of the water level controller (pressure switch). An open circuit occurs in the area from the control unit to the controller. To eliminate it, examine the correctness of the connections, possibly as a result of transportation, rearrangement or inadequate operation (lack of proper installation), the contact loop on the pressostat or software module was disconnected.
- Obstruction or disconnection of the water level sensor tube. Inspect the position of the hose, which is responsible for the presence and control of high pressure in a special water level controller. Since, as a result of inadequate operation, the device can vibrate, move (jump, move, etc.) both during spinning and washing. After that, as a result of improper installation of the device, an excess or a complete shutdown of the pressure switch appears. If you find incorrectness in connecting a special hose, you need to fix it. To do this, align, disconnect and reconnect it. After that, the unit should begin to work adequately.
You performed all the specified manipulations, but there is no result? Is the breakdown still showing? So, you can not do without professional help. Call the professionals of the business, the master of repair of Samsung washing machines.
